The formula: one measurement, four bands
The calculation is a band lookup, not a division, and the calculator shows the band edges so the answer can be checked by hand. Step 1, measure the lead hand: the top hand on the club — the left hand for a right-handed golfer — laid flat, palm up, from the main wrist crease straight to the tip of the middle finger. The lead hand decides because it wraps the top of the grip and sets how much grip the fingers can close around. Step 2, find the band: under 7.0 in is undersize, 7.0 to under 8.0 in is standard, 8.0 to under 9.0 in is midsize, and 9.0 in and over is jumbo. Step 3, the step against standard: undersize sits 1/64 in below standard, midsize 1/16 in above it, jumbo 1/8 in above it — the portable figures, since grip size names are not standardised between brands and the same name can measure slightly differently from one maker to the next. Step 4, the feel adjustment: preferring a slightly larger or smaller feel moves the answer one band, clamped at the ends, so a 7.5 in hand that prefers a larger feel reads midsize and an 8.5 in hand that prefers a smaller feel reads standard. The table is:

| Hand length | Grip size | Step vs standard | Typical glove size |
|---|---|---|---|
| 6.5 in | Undersize | −1/64 in | Small |
| 7.5 in | Standard | 0 | Medium to Medium-Large |
| 8.5 in | Midsize | +1/16 in | Large |
| 9.5 in | Jumbo | +1/8 in | XL to XXL |
Worked example: 7.5 in, standard feel
Take a golfer whose lead hand measures 7.5 in from wrist crease to middle fingertip, with a standard feel preference. Step 2 puts 7.5 in inside the 7.0 to under 8.0 in band, so the answer is a standard grip — step 0 against standard, typical glove size Medium to Medium-Large. Step 4 does not move it, because the feel preference is standard. The same hand with a larger-feel preference would read midsize, one step up, and an 8.5 in hand with a smaller-feel preference would read standard, one step down — which is exactly what the feel input is for: it records a preference the measurement alone cannot see. The centimetre input agrees: 19.1 cm is 7.52 in, still inside the standard band, so the answer stays standard.
How to read your result, and its limits
Three checks before regripping anything. First, measure the right hand: the trail hand is usually measured by mistake, and it gives a different number — the lead hand is the top hand on the club, and for a right-handed golfer that is the left hand. Second, use the glove size as a cross-check, not a second vote: a Medium-Large glove beside a standard result confirms it, but a Large glove beside a 7.5 in hand does not override the measurement — it flags a borderline case worth trying both ways, especially near a band edge like 8.0 in, where a tenth of an inch changes the answer. Third, confirm the feel before a full set: regrip one club first and play with it, because a grip that measures right but feels wrong will still cost shots, and golfers with sore hands often prefer one step larger whatever the measurement says. Build-up tape is the cheap way to test a step up: one wrap adds about 1/64 in, so moving a standard grip to midsize size takes roughly four wraps, though tape thickness varies. For the rest of the bag, the golf club length calculator sizes clubs from height and wrist-to-floor, the glove size converter converts glove sizes across systems, and the tennis grip size converter sizes a racket grip from hand measurements.
Common mistakes
- Measuring the trail hand. The bottom hand on the club gives a different length and can shift the band by a full step.
- Measuring with fingers curled or the hand bent. The hand must lie flat, palm up, or the wrist-crease-to-fingertip distance reads short.
- Treating the size name as exact. Brands do not standardise grip names, so the step against standard — 1/64, 1/16 or 1/8 in — is the figure that travels between makers.
- Regripping a full set on one measurement. Regrip one club, play with it, and only then commit the bag — especially near a band edge.
Frequently asked questions
What golf grip size do I need for a 7.5 inch hand?
A standard grip: 7.5 in falls inside the 7.0 to under 8.0 in standard band, with a typical glove size of Medium to Medium-Large. Enter your own hand length and feel preference above for your size.
How do I measure my hand for a golf grip?
Lay your lead hand — the top hand on the club, the left hand for a right-handed golfer — flat, palm up, and measure from the main wrist crease straight to the tip of your middle finger, in inches or centimetres.
What if my glove size disagrees with the calculator?
Trust the hand measurement first and treat the glove size as a cross-check: a disagreement flags a borderline case, especially near a band edge like 8.0 in, where trying both sizes on one club settles it.
Can grip tape change my grip size?
Yes, by a little: one wrap of build-up tape adds about 1/64 in, so roughly four wraps move a standard grip up to midsize size, though tape thickness varies. Tape is the cheap way to test a step up before buying new grips.
