Home › Text & Utility › Golf Club Length Calculator
Text & Utility

Golf Club Length Calculator

Off-the-rack golf clubs are built for one golfer — roughly 5 ft 10 in with average arms — and everyone else plays a set that is slightly the wrong length. Too long and your shots spray; too short and you crouch over every swing. Height alone gets you close, but two golfers at the same height can have very different arm lengths, which is why fitters also measure wrist-to-floor. This page combines both measurements into one length adjustment and applies it to the whole bag, so you can shop a number instead of a guess.

Free · No sign-up · Runs in your browser · First published 2026-10-30 · Updated November 2026

Wrist-to-floor: stand on a hard surface in flat shoes, arms hanging naturally, and have someone measure from the crease of your wrist to the floor. The standard lengths below are the usual men's standards — driver 45 in, 3-wood 43 in, 5-iron 38 in, 7-iron 37 in, putter 34 in — and the adjustment moves every club by the same amount. Heights are in centimetres — 178 cm is 5 ft 10 in.

Recommended club lengths
—

The formula: one adjustment, applied to the whole bag

Recommended length = standard length + adjustment, in inches, with the same adjustment applied to every club. The standard lengths are the usual men's standards: driver 45 in, 3-wood 43 in, 5-iron 38 in, 7-iron 37 in, putter 34 in. The adjustment is ToolFigure's own convention, built from the published height and wrist-to-floor bands rather than any one brands chart, and it combines two readings. The height adjustment steps by half an inch for every 3 inches of height away from 70 in (5 ft 10 in): height adjustment = round((height in inches − 70) ÷ 3) × 0.5 in. The wrist-to-floor adjustment steps by half an inch for every inch away from 34 in: wrist-to-floor adjustment = round((wrist-to-floor in inches − 34) ÷ 2 × 2) ÷ 2 in, which is the same as rounding (wrist-to-floor − 34) ÷ 2 to the nearest half inch. The final adjustment is the average of the two, rounded to the nearest half inch and capped at ±2 in. Averaging is the honest move: height alone ignores arm length, wrist-to-floor alone ignores posture, and the two together disagree less than either does alone.

Bar chart of the worked example's recommended club lengths: driver 45, 3-wood 43, 5-iron 38, 7-iron 37 and putter 34 inches
Recommended club lengths at standard adjustment, drawn as bars: the worked example below sits at a 45-inch driver.

Worked example: 178 cm, wrist-to-floor 86 cm

Take a golfer who is 178 cm tall with a wrist-to-floor of 86 cm. Convert both: 178 ÷ 2.54 = 70.1 in, and 86 ÷ 2.54 = 33.9 in. The height adjustment is round((70.1 − 70) ÷ 3) × 0.5 = round(0.03) × 0.5 = 0 in; the wrist-to-floor adjustment is (33.9 − 34) ÷ 2 = −0.07, rounded to the nearest half inch = 0 in; their average is 0 in — standard length. So the recommendation is driver 45 in, 3-wood 43 in, 5-iron 38 in, 7-iron 37 in, putter 34 in. The same arithmetic at other heights, each with a typical wrist-to-floor for that height, reads:

HeightWrist-to-floorAdjustmentDriver3-wood5-iron7-ironPutter
160 cm77 cm−1.5 in43.5 in41.5 in36.5 in35.5 in32.5 in
170 cm82 cm−0.5 in44.5 in42.5 in37.5 in36.5 in33.5 in
178 cm86 cmStandard45 in43 in38 in37 in34 in
185 cm89 cm+0.5 in45.5 in43.5 in38.5 in37.5 in34.5 in
193 cm93 cm+1.5 in46.5 in44.5 in39.5 in38.5 in35.5 in

Two more checks on the same formula: a 175 cm golfer with an 84 cm wrist-to-floor reads standard length — the height adjustment is 0 in and the wrist-to-floor adjustment is −0.5 in, averaging to 0 in after rounding — while a 190 cm golfer with a 92 cm wrist-to-floor reads +1 in, giving a 46 in driver, 44 in 3-wood, 39 in 5-iron, 38 in 7-iron and 35 in putter.

How to read your result, and its limits

Three checks before buying. First, where the two adjustments disagree by a full inch or more, get a fitting: that gap usually means long arms on a shorter frame or the reverse, and no average of the two is as good as a fitter watching you swing — the calculator result is then a starting point, not an answer. Second, women's standards run about an inch shorter — a women's driver standard is typically 44 in against the men's 45 in used here — so a woman buying from this page should read the adjustment, not the absolute lengths, and apply it to the women's standard set. Third, length is not the whole fitting: lie angle, shaft flex, grip size and swing speed all move the right club independently of length, and a putter is fitted by eye position and stroke as much as by height — demo the recommended length, ideally on a launch monitor, before committing to a full set. For the rest of the kit, the tennis grip size converter sizes a racquet handle from a palm measurement, and the bike frame size calculator sizes the other machine from an inseam.

Related tools: Helmet Size Converter — Helmet sizes from head circumference — letter size with inch range and hat size.

Frequently asked questions

What length golf clubs do I need at 5 ft 10 in?

With a typical wrist-to-floor of 86 cm, standard length: driver 45 in, 3-wood 43 in, 5-iron 38 in, 7-iron 37 in, putter 34 in. A 5 ft 10 in golfer with a much longer or shorter wrist-to-floor reading will move off standard by the averaged adjustment.

How is golf club length calculated here?

One adjustment, applied to every club: the height adjustment steps half an inch per 3 inches from 70 in, the wrist-to-floor adjustment steps half an inch per inch from 34 in, and the final adjustment is their average rounded to the nearest half inch, capped at plus or minus 2 in.

What if my height and wrist-to-floor point to different lengths?

That gap usually means long arms on a shorter frame or the reverse. The calculator averages them, but where the two adjustments disagree by a full inch or more, treat the result as a starting point and get a shop fitting.

Are womens golf club lengths different?

Yes, typically about an inch shorter — a women's driver standard is usually 44 in against the men's 45 in used here. Read the adjustment from this page and apply it to the women's standard set.

Ahsan ul Haq
Editor, ToolFigure

Every ToolFigure calculator is checked against hand-worked examples before it is published — the same worked examples you can follow on each page. More about ToolFigure →

Related tools

Calculators that show their working

Free forever · No sign-up · Every result comes with its formula and a worked example.

Browse all tools